![]() With the vehicle in PARK and the engine running, insert tool J-51155 into the pipe. Refer to Table A for the correct position for a given vehicle. The handle on tool J-51155 has two positions, red and blue (see Figure 6 and 7). Tool CVT Oil Level Quick Check Gauge (J-51155) can now be used to determine the CVT fluid level. Pull to remove the cap from the charging pipe. Remove tool J-52611 from the cap (see Figure 5). Notice the gap between the cap and charge pipe in Figure 4. The cap’s locking tab is unlocked while squeezing. ![]() ![]() Squeeze the tool toward the cap, and then slightly lift the cap (see Figure 3). NOTE: The tool shown in Figures 3 and 4 is the same as the one shown in Figure 2, but looks slightly different. Install special tool CVT Charge Pipe Cap Release (J-52611) where shown in Figure 3. Shift the transmission into REVERSE for 5 seconds.Ħ. Shift the transmission into DRIVE for 5 seconds.ĥ. Shift the transmission into REVERSE for 5 seconds.Ĥ. Using a scan tool, ensure that the CVT fluid operating temperature is within the range of 170☏-180☏ (77☌-82☌).ģ. Park the vehicle on level ground (engine running, parking brake set).Ģ. Search for J-5261 and then select the Charge Pipe Cap Release Tool.ġ. A video on how to use tools is available on. Steps 1 through 6 will ensure that CVT fluid is properly distributed throughout the transmission. Also, tools can be obtained from Tech-Mate at 1-80. Special tools CVT Oil Level Quick Check Gauge (J-51155) and CVT Charge Pipe Cap Release (J-52611) are now available from Nissan and dealers, Figure 1 and 2. *APPLIED VEHICLES equipped with CVT ONLY Figure 1
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |